Show simple item record

dc.contributor.authorChoon-Lai Tan
dc.contributor.authorAnthony P. Parker
dc.contributor.authorChantz W. V. Cassell
dc.date.accessioned2017-05-09T00:14:12Z
dc.date.available2017-05-09T00:14:12Z
dc.date.copyrightMay, 2004
dc.date.issued2004
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28438#229_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/130703
dc.description.abstractPressure vessel steels exhibit the Bauschinger effect that significantly reduces post-autofrettage residual compressive hoop stresses in the near-bore region in comparison with ‘ideal’ (elastic-perfectly plastic) behavior. These reduced hoop stress profiles were calculated using Von Mises’ criterion via a nonlinear analysis for the case of open-end (engineering plane strain) autofrettage. These profiles were then used to obtain stress intensity factor solutions via the Boundary Integral Equation (BIE) method, commonly known as the Boundary Element Method (BEM). Results are presented for tubes of diameter ratio 2 and 2.5 with an internal semi-elliptical surface crack having a maximum depth/surface length ratio of 0.4 (i.e., an eccentricity of 0.8). Crack depths range from 20% to 80% of wall thickness and results are presented for seven locations on the crack front from maximum depth to free surface. For crack depths up to 20% of wall thickness there is a significant reduction in magnitude of autofrettage stress intensity factor due to Bauschinger effect. For typical overstrain levels this reduction is approximately 30% of “ideal” values. Such a reduction may, in turn, cause an order of magnitude reduction in the fatigue lifetime of the vessel.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStress Intensity Factors for a Curved-Front Internal Crack in an Autofrettaged Tube With Bauschinger Effect
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1689358
dc.journal.fristpage229
dc.journal.lastpage233
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsFracture (Materials)
dc.keywordsAutofrettage AND Wall thickness
dc.treeJournal of Pressure Vessel Technology:;2004:;volume( 126 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record