Show simple item record

dc.contributor.authorA. Bhattacharya
dc.contributor.authorV. Venkat Raj
dc.date.accessioned2017-05-09T00:14:11Z
dc.date.available2017-05-09T00:14:11Z
dc.date.copyrightMay, 2004
dc.date.issued2004
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28438#169_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/130694
dc.description.abstractSecond and fourth order polynomials describing the yield criterion for perforated plates with square penetration pattern were developed following the methodology shown by Hill (1950) and later by Reinhardt (2001) for triangular penetration pattern. The inadequacy of Hill’s (1950) criterion to describe the yield surface of the equivalent solid plate was observed by Reinhardt (2001). Unlike in the case of triangular penetration pattern, the second-order polynomial satisfies the uniqueness of yield stresses after symmetric rotation in the case of square penetration pattern, even though the second order polynomial is incomplete as it cannot satisfy the yield criterion for pure shear. However, the fourth order polynomial is found to satisfy the symmetry and boundary conditions arising from biaxial loadings completely and shows closer agreement with the finite-element results obtained by the authors as compared to the second-order polynomial. Some of the finite-element results were compared with the experimental results of Litewka (1991) and the agreement between them was found to be satisfactory. The effect of out-of-plane stresses have not been considered in the present investigation as these are found to be negligible in case of thin perforated plates, for which plane stress condition was assumed in the finite element analysis.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleYield Criterion for Thin Perforated Plates With Square Penetration Pattern
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1687383
dc.journal.fristpage169
dc.journal.lastpage178
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsShear (Mechanics)
dc.keywordsPlates (structures)
dc.keywordsBoundary-value problems
dc.keywordsPolynomials
dc.keywordsYield stress
dc.keywordsFinite element model
dc.keywordsRotation
dc.keywordsFinite element methods AND Finite element analysis
dc.treeJournal of Pressure Vessel Technology:;2004:;volume( 126 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record