Show simple item record

dc.contributor.authorG. Bruno
dc.contributor.authorB. D. Dunn
dc.date.accessioned2017-05-09T00:14:08Z
dc.date.available2017-05-09T00:14:08Z
dc.date.copyrightAugust, 2004
dc.date.issued2004
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28442#284_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/130674
dc.description.abstractThe residual stress (RS) in two curved plates cut from a large welded propellant tank for spacecrafts was investigated nondestructively by neutron and laboratory x-ray diffraction. Each plate had two weld beads symmetric to a central monoblock reinforcement. One plate had received a post-weld heat-treatment. The two nondestructive test techniques successfully determined both the bulk (thickness averaged) and the surface stress state, due to the highly different penetration of these radiations in metals. In the as-welded tank, both neutrons and x-rays show a stress level (both in the axial and hoop directions) higher in the heat affected zone (HAZ) than in the weld pool (300 against 160 MPa). A considerable degree of relaxation annealing was observed by neutron diffraction after the application of the heat treatment. In this case, the hoop stress in the HAZ relaxes from about 300 to about 100 MPa. X-rays also permitted the separate determination of the α and β-phase stresses and the calculation of the macro-RS. The latter showed the bending deformation resulting from the cut of the plates from the original tank. The average stress measured by x-rays was found to be very similar to the RS obtained by neutron diffraction technique.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSurface and Bulk Residual Stress in Ti6Al4V Welded Aerospace Tanks
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1763932
dc.journal.fristpage284
dc.journal.lastpage292
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsNeutrons AND X-rays
dc.treeJournal of Pressure Vessel Technology:;2004:;volume( 126 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record