Show simple item record

dc.contributor.authorAmer Hameed
dc.contributor.authorR. D. Brown
dc.contributor.authorJohn Hetherington
dc.date.accessioned2017-05-09T00:14:07Z
dc.date.available2017-05-09T00:14:07Z
dc.date.copyrightNovember, 2004
dc.date.issued2004
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28446#497_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/130665
dc.description.abstractIt may be necessary to provide a radial opening such as gas evacuator holes, or an opening to operate the unlocking of the bolt mechanism by means of exhaust gases, in a gun barrel, which is a thick walled cylinder. A three dimensional finite element analysis has been performed to evaluate the effect of introducing a radial cross-bore in an autofrettaged thick-walled cylinder. From the analysis of the cross-bored autofrettaged cylinder, it was observed that there is a severe localized change in the residual stress profile in the vicinity of the cross-bore. The residual circumferential stress increases in compression at the bore. Similarly it increases in tension at the outer diameter, thus making the outer diameter more vulnerable to fatigue failure or crack initiation under stresses arising as a result of firing. Analyses were also performed by varying the cross-bore diameter and it was observed that, by increasing the diameter of the radial hole, the residual circumferential stress at the bore reduces, while it increases at the outer diameter, with an increase in the cross bore diameter. The re-pressurization pressure of an autofrettaged cylinder with radial cross-bore was found to be approximately 65 percent less than the actual autofrettage pressure in a particular case discussed in this paper. A comparison is also made with the residual stress field which would result if the cross-bore was machined before autofrettage.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Study of the Residual Stress Distribution in an Autofrettaged, Thick-Walled Cylinder With Cross-Bore
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1811111
dc.journal.fristpage497
dc.journal.lastpage503
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsStress
dc.keywordsStress concentration
dc.keywordsCylinders
dc.keywordsAutofrettage
dc.keywordsGun barrels AND Tension
dc.treeJournal of Pressure Vessel Technology:;2004:;volume( 126 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record