Show simple item record

dc.contributor.authorA. Tamer Özdemir
dc.contributor.authorLyndon Edwards
dc.date.accessioned2017-05-09T00:13:13Z
dc.date.available2017-05-09T00:13:13Z
dc.date.copyrightJanuary, 2004
dc.date.issued2004
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27055#129_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/130148
dc.description.abstractMany analytical and experimental techniques utilize two-dimensional analysis approach to determine residual strains and stresses at cold expanded holes. In the present work, a recently developed technique of hole drilling was used to sketch stress patterns in three-dimension at a particular orientation of split-sleeve cold expanded holes. At this orientation, similarities were obtained in between the present results and the stress distributions measured by Fourier series expansion, neutron diffraction methods and prediction of a recent finite element analysis. It is clear that after cold expansion there are significant variations in residual hoop stresses at different sections through the thickness of the plate. However, finish reaming and de-burring around the hole redistributes residual stresses such that hoop stresses adjacent to the hole along its entire length becomes more compressive and almost uniform. Finally a correlation between stress pattern and crack profile, displaying the through-thickness effect was shown.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThrough-Thickness Residual Stress Distribution After the Cold Expansion of Fastener Holes and Its Effect on Fracturing
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1634278
dc.journal.fristpage129
dc.journal.lastpage135
dc.identifier.eissn1528-8889
dc.keywordsResidual stresses
dc.keywordsStress
dc.keywordsStress concentration
dc.keywordsThickness
dc.keywordsDrilling
dc.keywordsFasteners
dc.keywordsFracture (Process)
dc.keywordsFracture (Materials)
dc.keywordsFourier series
dc.keywordsNeutron diffraction
dc.keywordsDimensions AND Finishes
dc.treeJournal of Engineering Materials and Technology:;2004:;volume( 126 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record