Show simple item record

dc.contributor.authorRui Wu
dc.contributor.authorRolf Sandström
dc.contributor.authorFacredin Seitisleam
dc.date.accessioned2017-05-09T00:13:13Z
dc.date.available2017-05-09T00:13:13Z
dc.date.copyrightJanuary, 2004
dc.date.issued2004
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27055#87_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/130142
dc.description.abstractWith modern welding methods, satisfactory microstructures in 9%CrMoV (P91) steel can be obtained with a modest variation in hardness and prior austenite grain size. However, there is always a risk that significant deviations in the properties can be obtained, if the welding parameters are not optimized. In the present paper the role of extra coarse grains in the heat affected zone (HAZ) has been studied. Creep tests were carried out at 600°C for parent metal, weld metal, cross weld, simulated extra coarse grained HAZ, and simulated intercritical HAZ of a 9%CrMoV (P91) steel. The parent metal, the cross welds, the weld metal, and the simulated intercritical HAZ had about the same rupture strength except at long rupture times, where the values for the cross welds were considerably lower. In the cross welds, rupture took place in the intercritical HAZ at longer times (Type IV cracking). The simulated extra coarse grains gave considerably longer rupture times, lower strain rate and lower creep ductility than the parent metal and the weld metal. The creep strain behavior was successfully analyzed using the Omega model where the log creep strain rate is linear in the creep strain.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleInfluence of Extra Coarse Grains on the Creep Properties of 9 Percent CrMoV (P91) Steel Weldment
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1631025
dc.journal.fristpage87
dc.journal.lastpage94
dc.identifier.eissn1528-8889
dc.keywordsCreep
dc.keywordsMetals
dc.keywordsSteel
dc.keywordsRupture
dc.keywordsFracture (Process)
dc.keywordsStress
dc.keywordsWelded joints
dc.keywordsWelding AND Heat
dc.treeJournal of Engineering Materials and Technology:;2004:;volume( 126 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record