Show simple item record

dc.contributor.authorJixi Zhang
dc.contributor.authorYanyao Jiang
dc.date.accessioned2017-05-09T00:13:11Z
dc.date.available2017-05-09T00:13:11Z
dc.date.copyrightApril, 2004
dc.date.issued2004
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27057#164_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/130123
dc.description.abstractAn experimental study was conducted on the inhomogeneous plastic deformation of 1045 steel subjected to monotonic tension and cyclic tension-compression. Small strain gages were used to characterize the local deformation and transmission electron microscopy (TEM) was used to study the microstructures associated with the observed deformation phenomenon. Under monotonic tension, the strain of the Lüders front was lower than the full Lüders strain. The local strains were inhomogeneous even at the work-hardening stage. Under stress-controlled cyclic loading with stress amplitudes below the lower yield stress, cyclic deformation consisted of an incubation stage, a significantly inhomogeneous cyclic softening stage, and a saturation stage. Inhomogeneous cyclic plasticity persisted at the saturation stage. A monotonic tension preload can eliminate the incubation stage in the subsequent cyclic loading. Under asymmetric cyclic loading with a mean stress, the cyclic plastic deformation was accompanied by noticeable inhomogeneous ratcheting deformation. TEM was used to analyze the distribution and evolution of the dislocation structures at different locations of the specimen. With increasing loading cycles, the dislocation substructures evolved in a sequence of loose tangles, thick veins, long walls, elongated cells, and equiaxial cells. Based upon the mechanical experiments and observations of dislocation arrangements, the mechanisms governing inhomogeneous cyclic plastic deformation were discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Study of Inhomogeneous Plastic Deformation of 1045 Steel
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1647125
dc.journal.fristpage164
dc.journal.lastpage171
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsSteel
dc.keywordsStress
dc.keywordsDislocations
dc.keywordsCycles
dc.keywordsTension
dc.keywordsStrain gages
dc.keywordsGages AND Yield stress
dc.treeJournal of Engineering Materials and Technology:;2004:;volume( 126 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record