Show simple item record

dc.contributor.authorAdrian T. DeWald
dc.contributor.authorJon E. Rankin
dc.contributor.authorMichael R. Hill
dc.contributor.authorHao-Lin Chen
dc.contributor.authorMatthew J. Lee
dc.date.accessioned2017-05-09T00:13:07Z
dc.date.available2017-05-09T00:13:07Z
dc.date.copyrightOctober, 2004
dc.date.issued2004
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27063#465_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/130104
dc.description.abstractThis paper examines the effects of laser peening on Alloy 22 (UNS N06022), which is the proposed material for use as the outer layer on the spent-fuel nuclear waste canisters to be stored at Yucca Mountain. Stress corrosion cracking (SCC) is a primary concern in the design of these canisters because tensile residual stresses will be left behind by the closure weld. Alloy 22 is a nickel-based material that is particularly resistant to corrosion; however, there is a chance that stress corrosion cracking could develop given the right environmental conditions. Laser peening is an emerging surface treatment technology that has been identified as an effective tool for mitigating tensile redisual stresses in the storage canisters. The results of laser-peening experiments on Alloy 22 base material and a sample 33 mm thick double-V groove butt-weld made with gas tungsten arc welding (GTAW) are presented. Residual stress profiles were measured in Alloy 22 base material using the slitting method (also known as the crack-compliance method), and a full 2D map of longitudinal residual stress was measured in the sample welds using the contour method. Laser peening was found to produce compressive residual stress to a depth of 3.8 mm in 20 mm thick base material coupons. The depth of compressive residual stress was found to have a significant dependence on the number of peening layers and a slight dependence on the level of irradiance. Additionally, laser peening produced compressive residual stresses to a depth of 4.3 mm in the 33 mm thick weld at the center of the weld bead where high levels of tensile stress were initially present.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAssessment of Tensile Residual Stress Mitigation in Alloy 22 Welds Due to Laser Peening
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1789957
dc.journal.fristpage465
dc.journal.lastpage473
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsLaser hardening
dc.keywordsLasers
dc.keywordsShot peening
dc.keywordsIndium alloys
dc.keywordsWelded joints AND Alloys
dc.treeJournal of Engineering Materials and Technology:;2004:;volume( 126 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record