• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Mechanical Behavior in the Silicon Carbide Reinforced Aluminum 6061 Composites Degraded by Room or High Temperature 3.5% NaCl Solution

    Thumbnail
    View/Open
    JEMTA8-27063#436_1.pdf (1.445Mb)
    Date
    2004
    Author
    J. J. Ahn
    S. Ochiai
    Metadata
    Show full item record
    Abstract
    Mechanical properties of silicon carbide particle reinforced aluminum alloy 6061 composites with 5% and 10% (SiCp/Al) as well as aluminum alloy 6061 (AA6061) degraded by neutral 3.5% NaCl solution were examined by tensile tests and micro Vickers hardness measurement. The samples were degraded in the neutral 3.5% NaCl solution for a month (≑720 h) at 23°C (room temperature corrosion, RC) and 100°C (high temperature corrosion, HC). It is noted from surface observation of the corrosively degraded samples that the RC-samples (SiCp/Al and AA6061) were degraded by pitting around intermetallic compounds and SiC particles while corrosive degradation of the HC-samples was caused by synergy effect of pitting and intergranular corrosion. Corrosion reaction of the RC-samples was limited to their surface but the HC-samples were received severe corrosion damage until inside part. Thereby, mechanical strength of the latter (a maximum of 220 MPa) was lower than that of the former (a maximum of 330 MPa). Reduction of proof stress, σ0.2%, and ultimate tensile strength, σUTS, was greater in the SiCp/Al than in the AA6061 in the case of the same condition. The result to analyze the experimental data regressively showed that reduction of tensile strength for the RC-samples was proportional to the size of pit while tensile strength of the HC-samples was proportional to the ratio of corroded area to cross-section area. The empirical equations to evaluate the mechanical strength of both cases of the corrosively degraded samples (RC- and HC-samples) were proposed.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/130099
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV