Show simple item record

dc.contributor.authorAngela O. Nieckele
dc.contributor.authorMo⁁nica F. Naccache
dc.contributor.authorMarcos S. P. Gomes
dc.date.accessioned2017-05-09T00:12:53Z
dc.date.available2017-05-09T00:12:53Z
dc.date.copyrightMarch, 2004
dc.date.issued2004
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26516#72_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/129957
dc.description.abstractFor the present work, a numerical simulation of the 100% oxy-firing combustion process inside an industrial aluminum remelting reverb furnace is presented. Three different configurations were analyzed: (i) a staged combustion process with parallel injection jets for oxygen and natural gas, (ii) a staged combustion process with a divergent jet for the oxygen, and (iii) a non-staged combustion process, with parallel jets. In all the cases, the injections were directed towards the aluminum bath, which was maintained at constant temperature. The numerical procedure was based on the finite volume formulation. The κ-ε model of turbulence was selected for simulating the turbulent flow field. The combustion process was calculated based on the finite rate models of Arrhenius and Magnussen, and the Discrete Transfer Radiation model was employed for predicting the radiation heat transfer. The numerical predictions allowed the determination of the flame patterns, species concentration distribution, temperature and velocity fields. This kind of analysis can be a powerful tool for evaluating design options such as the type, number and positioning of the burners. The present work illustrates a preliminary comparison of three types of burners. From the results obtained, the staged combustion process with a divergent jet presented the best configuration, since the flame length was not too long as to damage the refractory wall. Further it presented the largest region with low water vapor concentration close to the aluminum surface.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNumerical Modeling of an Industrial Aluminum Melting Furnace
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue1
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.1625396
dc.journal.fristpage72
dc.journal.lastpage81
dc.identifier.eissn1528-8994
dc.keywordsTemperature
dc.keywordsCombustion
dc.keywordsAluminum
dc.keywordsComputer simulation
dc.keywordsFlames
dc.keywordsFurnaces
dc.keywordsOxygen
dc.keywordsTurbulence
dc.keywordsEjectors AND Natural gas
dc.treeJournal of Energy Resources Technology:;2004:;volume( 126 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record