Show simple item record

dc.contributor.authorBrandon J. Jellison
dc.contributor.authorResearch Assistant
dc.contributor.authorDavid C. Nelson
dc.contributor.authorHarold R. Kess
dc.contributor.authorResearch Assistant
dc.contributor.authorDouglas E. Adams
dc.date.accessioned2017-05-09T00:12:34Z
dc.date.available2017-05-09T00:12:34Z
dc.date.copyrightSeptember, 2004
dc.date.issued2004
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26333#498_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/129758
dc.description.abstractThe modes of vibration of manufactured parts can be good indicators of the overall quality of the manufacturing process. That is, deviations in the modal frequencies or modal vectors of mechanical parts can help to identify outlier or systemic problems in the raw materials or fabrication procedure. A novel method for characterizing nonuniformities in homogeneous symmetric parts using pseudorepeated modal frequencies is discussed in this paper. It is demonstrated that the spacing between pseudorepeated roots in dominantly symmetric manufactured parts is a direct indicator of nonuniformities (i.e., inclusions, voids) in the stiffness or mass distributions. Smaller differences between split-peaks indicate less nonuniformity, and hence, higher quality parts. A simple fourth-order lumped parameter model is used to elaborate on this technique analytically, a representative finite element model is used to further this development, root locus techniques are used to study the sensitivity to nonuniformities, and acceleration response data from impact vibration tests on deep drawn hemispherical shells are used to verify the approach experimentally.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNondestructive Evaluation of Parts With Degenerate Modes Using Pseudorepeated Roots
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue3
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.1789536
dc.journal.fristpage498
dc.journal.lastpage508
dc.identifier.eissn1528-9028
dc.keywordsManufacturing
dc.keywordsNondestructive evaluation
dc.keywordsVibration
dc.keywordsFrequency
dc.keywordsShells AND Stiffness
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2004:;volume( 126 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record