Show simple item record

dc.contributor.authorJ. Błachut
dc.date.accessioned2017-05-09T00:11:15Z
dc.date.available2017-05-09T00:11:15Z
dc.date.copyrightFebruary, 2003
dc.date.issued2003
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28423#91_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/129012
dc.description.abstractThe paper discusses the load-carrying capacity of toroidal shells with closed circular cross section and loaded by static external pressure. Details about the manufacturing, pre-experiment measurements and testing of three, nominally different, steel toroids are provided. Two of them were manufactured from mild steel by spinning two halves and then welding them around the inner and outer equatorial perimeters. The third one has been assembled by welding four 90-deg stainless elbows. The outer diameter of these models was about 300 mm and the wall thickness varied from 2.0 to 3.0 mm. The hoop radius-to-thickness ratio, r/t, varied from about 15 to 30. The experimental collapse pressures were in the range from 4 to 8 MPa. Comparisons with numerical results are also provided.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCollapse Tests on Externally Pressurized Toroids
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1522417
dc.journal.fristpage91
dc.journal.lastpage96
dc.identifier.eissn1528-8978
dc.keywordsLoad bearing capacity
dc.keywordsBuckling
dc.keywordsCollapse
dc.keywordsShells
dc.keywordsWall thickness
dc.keywordsSteel
dc.keywordsThickness
dc.keywordsExternal pressure
dc.keywordsPressure
dc.keywordsMeasurement
dc.keywordsTesting AND Bifurcation
dc.treeJournal of Pressure Vessel Technology:;2003:;volume( 125 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record