Show simple item record

dc.contributor.authorJin-Su Kim
dc.contributor.authorYun-Won Park
dc.contributor.authorBon-Geol Koo
dc.contributor.authorJae-Boong Choi
dc.contributor.authorYoung-Jin Kim
dc.date.accessioned2017-05-09T00:11:15Z
dc.date.available2017-05-09T00:11:15Z
dc.date.copyrightFebruary, 2003
dc.date.issued2003
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28423#46_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/129004
dc.description.abstractThe reactor pressure vessel is usually clad with stainless steel to prevent corrosion and radiation embrittlement, and thus, the population of subclad cracks is higher than that of surface cracks. In fact, a number of subclad cracks have been found during in-service-inspections. These subclad cracks should be assumed for a safe operation under normal conditions and faulted conditions such as pressurized thermal shock (PTS). There are several elastic stress intensity factor (SIF) solutions for subclad cracks which are used for ASME fracture assessment procedures. However, these solutions are known to be overly conservative due to intrinsic assumptions. In this paper, full 3-D elastic-plastic finite element analyses were performed to investigate the validity of the present ASME code in evaluating the integrity of vessel under PTS conditions. The solution in ASME Section XI code gives accurate SIF values when the crack tip is close to cladding. However, the difference between the code solution and elastic plastic finite element analysis (EPFEA) results become significant with increasing crack depth. This difference is caused by the stress discontinuity at the interface between cladding and parent material. Elastic finite element analysis (EFEA) results, which do not consider plastic deformation at the clad material, also showed a big difference compared to those from EPFEA. Therefore, it is recommended to perform EPFEA for the accurate assessment of subclad cracks under PTS which causes plastic deformation at the cladding.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Finite Element Study on the Integrity Evaluation Method of Subclad Cracks Under Pressurized Thermal Shock Transients
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1498846
dc.journal.fristpage46
dc.journal.lastpage51
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsFracture (Materials)
dc.keywordsFinite element analysis
dc.keywordsThermal shock
dc.keywordsDeformation
dc.keywordsSurface cracks AND Evaluation methods
dc.treeJournal of Pressure Vessel Technology:;2003:;volume( 125 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record