Show simple item record

dc.contributor.authorA. N. Shuaib
dc.contributor.authorM. K. Khraisheh
dc.contributor.authorI. M. Allam
dc.contributor.authorS. S. Al-Anizi
dc.contributor.authorN. Merah
dc.date.accessioned2017-05-09T00:11:14Z
dc.date.available2017-05-09T00:11:14Z
dc.date.copyrightFebruary, 2003
dc.date.issued2003
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28423#19_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/129001
dc.description.abstractAn experimental study has been conducted to evaluate the effect of roller expansion of heat exchanger tubes in enlarged tubesheet holes on joint strength, tube wall reduction (i.e., thinning), and strain hardening of the tubes and surrounding tubesheet ligaments. Different levels of tube-to-tubesheet hole clearance, or overtolerance (OT), were investigated to simulate tubesheet in-service, and during-maintenance, hole enlargement process. The experimental results have shown that, in spite of increasing overtolerance level by up to seven times the maximum value allowed by the Tubular Exchanger Manufacturer Association (TEMA) standard, the average strength of the test joints has not declined below the strength of joints in the allowed TEMA OT range. Percent wall reduction (WR) of the expanded tube was found to increase linearly with increasing overtolerance value; although its maximum value remained well below the wall reduction limit for which a joint is rejected in industry. An observed increase in hardness of the expanded tube material is evidence of the high degree of strain hardening to which the expanded tubes are subjected compared with the surrounding ligaments. Pull-out forces, calculated using existing analytical methods, were found to compare well with the experimental results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Investigation of Heat Exchanger Tubesheet Hole Enlargement
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1533799
dc.journal.fristpage19
dc.journal.lastpage25
dc.identifier.eissn1528-8978
dc.keywordsForce
dc.keywordsClearances (Engineering)
dc.keywordsHeat exchangers
dc.keywordsRollers
dc.keywordsWork hardening
dc.keywordsMaintenance
dc.keywordsPressure AND Analytical methods
dc.treeJournal of Pressure Vessel Technology:;2003:;volume( 125 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record