| dc.contributor.author | John H. Underwood | |
| dc.contributor.author | David B. Moak | |
| dc.contributor.author | Anthony P. Parker | |
| dc.contributor.author | Michael J. Audino | |
| dc.date.accessioned | 2017-05-09T00:11:14Z | |
| dc.date.available | 2017-05-09T00:11:14Z | |
| dc.date.copyright | February, 2003 | |
| dc.date.issued | 2003 | |
| dc.identifier.issn | 0094-9930 | |
| dc.identifier.other | JPVTAS-28423#7_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/128998 | |
| dc.description.abstract | Yield pressure corresponding to a small permanent OD strain was measured in quasi-static laboratory tests of autofrettaged ASTM A723 steel cannon pressure vessels. Yield pressure was found to be a consistent ratio of the yield strength measured from specimens located in close proximity to the area of observed yielding. Yield pressure measurements for dynamic cannon firing with typically a 5-ms pressure pulse duration gave 14% higher yield pressures, attributed to strain rate effects on plastic deformation. Calculated Von Mises yield pressure for the laboratory test conditions, including the Bauschinger-modified ID residual stress and open-end vessel conditions, agreed with measured yield pressure within 3–5%. Calculated yield pressure was found to be insensitive to the value of axial residual stress, since axial stress is the intermediate value in the Von Mises yield criterion. A description of yield pressure normalized by yield strength was given for autofrettaged A723 open-end pressure vessels over a range of wall ratio and degree of autofrettage, including effects of Bauschinger-modified residual stress. This description of yield pressure is proposed as a design procedure for cannons and other pressure vessels. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Yield Pressure Measurements and Analysis for Autofrettaged Cannons | |
| dc.type | Journal Paper | |
| dc.journal.volume | 125 | |
| dc.journal.issue | 1 | |
| dc.journal.title | Journal of Pressure Vessel Technology | |
| dc.identifier.doi | 10.1115/1.1526857 | |
| dc.journal.fristpage | 7 | |
| dc.journal.lastpage | 10 | |
| dc.identifier.eissn | 1528-8978 | |
| dc.keywords | Pressure | |
| dc.keywords | Steel | |
| dc.keywords | Pressure measurement | |
| dc.keywords | Pressure vessels | |
| dc.keywords | Stress | |
| dc.keywords | Yield strength | |
| dc.keywords | Autofrettage | |
| dc.keywords | Artillery | |
| dc.keywords | Firing (materials) | |
| dc.keywords | Design AND Vessels | |
| dc.tree | Journal of Pressure Vessel Technology:;2003:;volume( 125 ):;issue: 001 | |
| dc.contenttype | Fulltext | |