Show simple item record

dc.contributor.authorJoseph Perry
dc.contributor.authorJacob Aboudi
dc.date.accessioned2017-05-09T00:11:09Z
dc.date.available2017-05-09T00:11:09Z
dc.date.copyrightAugust, 2003
dc.date.issued2003
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28427#248_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/128957
dc.description.abstractIn the optimal design of a modern gun barrel, there are two main objectives to be achieved: increasing its strength-weight ratio and extending its fatigue life. This can be carried out by generating a residual stress field in the barrel wall, a process known as autofrettage. It is often necessary to machine the autofrettaged cylinder to its final configuration, an operation that will remove some of the desired residual stresses. In order to achieve a residual stress distribution which is as close as possible to the practical one, the following assumptions have been made in the present research on barrel analysis: A von Mises yield criterion, isotropic strain hardening in the plastic region in conjunction with the Prandtl-Reuss theory, pressure release taking into consideration the Bauschinger effect and plane stress conditions. The stresses are calculated incrementally by using the finite difference method, whereby the cylinder wall is divided into N-rings at a distance Δr apart. Machining is simulated by removing rings from both sides of the cylindrical surfaces bringing the cylinder to its final shape. After a theoretical development of the procedure and writing a suitable computer program, calculations were performed and a good correlation with the experimental results was found. The numerical results were also compared with other analytical and experimental solutions and a very good correlation in shape and magnitude has been obtained.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleElasto-Plastic Stresses in Thick Walled Cylinders
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1593078
dc.journal.fristpage248
dc.journal.lastpage252
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsResidual stresses
dc.keywordsStress
dc.keywordsCylinders
dc.keywordsAutofrettage AND Stress concentration
dc.treeJournal of Pressure Vessel Technology:;2003:;volume( 125 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record