Show simple item record

dc.contributor.authorJingyu Shi
dc.contributor.authorS. A. Domanti
dc.contributor.authorD. L. S. McElwain
dc.date.accessioned2017-05-09T00:10:23Z
dc.date.available2017-05-09T00:10:23Z
dc.date.copyrightApril, 2003
dc.date.issued2003
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27045#170_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/128498
dc.description.abstractIn view of the well-known disparity between predictions from temper rolling models and measured values from rolling mills, there is a need to obtain a better understanding of the effect of roll asperities on the yielding characteristics of the rolled strip. This paper models a roll with asperities as a rigid body with a regular serrated surface and the rolling process as an indentation, and uses the plane strain model and slip-line theory to determine the critical pressure that is required to yield the strip throughout the thickness beneath the tips of the asperities. The strip is also under lateral tension at both ends. The emphasis of the paper is the effect of the lateral tension and the thickness of the strip on the critical pressure. For the case when the indenting surface has sharp teeth, the critical pressure can be found in close form. For the case when the indenting surface has blunt teeth, a robust approximate scheme for estimation of the critical values that does not require extensive computation is given and this scheme can be used in an on-line control process. It is found that when the tooth angle is smaller than a critical angle, the sharper the tooth, the lower the average critical pressure needed to make the strip yield. When the tooth angle is larger than the critical angle, then the blunter the tooth, the lower the pressure that is needed. The effect of the asperities is to reduce the critical pressure and it is found that this effect is more pronounced for thin strips than for thick strips. The lateral tension reduces the critical pressure further. These findings give some implications for the rolling of metal sheets.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Approximate Method of Estimating the Yield of a Strip Under Tension Cut by Serrated Surfaces on Opposite Faces
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1555656
dc.journal.fristpage170
dc.journal.lastpage175
dc.identifier.eissn1528-8889
dc.keywordsPressure
dc.keywordsStress
dc.keywordsStrips
dc.keywordsTension
dc.keywordsThickness AND Wedges
dc.treeJournal of Engineering Materials and Technology:;2003:;volume( 125 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record