Show simple item record

dc.contributor.authorBa Nghiep Nguyen
dc.contributor.authorKenneth I. Johnson
dc.contributor.authorMohammad A. Khaleel
dc.date.accessioned2017-05-09T00:10:22Z
dc.date.available2017-05-09T00:10:22Z
dc.date.copyrightApril, 2003
dc.date.issued2003
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27045#133_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/128493
dc.description.abstractThis paper describes an inverse approach (IA) formulation for the analysis of tubes under free hydroforming conditions. The IA formulation is derived from that of Guo et al. established for flat sheet hydroforming analysis using constant strain triangular membrane elements. First, an incremental analysis of free hydroforming for a hot-dip galvanized (HG/Z140) DP600 tube is performed using the Marc finite element code. The deformed geometry obtained at the last converged increment is then used as the final configuration in the inverse analysis. This comparative study allows an assessment of the predictive capability of the inverse analysis. The results are compared with the experimental values determined by Asnafi and Skogsgärdh. After that, a procedure based on a forming limit diagram (FLD) is described as a means to adjust the process parameters such as the axial feed and internal pressure. Finally, the adjustment process is illustrated through a re-analysis of the same tube using the inverse approach.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAnalysis of Tube Free Hydroforming Using an Inverse Approach With FLD-Based Adjustment of Process Parameters1
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1555651
dc.journal.fristpage133
dc.journal.lastpage140
dc.identifier.eissn1528-8889
dc.keywordsPressure
dc.keywordsFinite element analysis
dc.keywordsMembranes
dc.keywordsGeometry
dc.keywordsFailure
dc.keywordsThickness AND Deformation
dc.treeJournal of Engineering Materials and Technology:;2003:;volume( 125 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record