Show simple item record

dc.contributor.authorV. C. Prantil
dc.contributor.authorG. S. Ramaswamy
dc.contributor.authorM. T. Lusk
dc.contributor.authorM. L. Callabresi
dc.contributor.authorJ. F. Lathrop
dc.date.accessioned2017-05-09T00:10:22Z
dc.date.available2017-05-09T00:10:22Z
dc.date.copyrightApril, 2003
dc.date.issued2003
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27045#116_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/128491
dc.description.abstractThis paper illustrates the application of a new multiphase material model for simulating distortion and residual stresses in carburized and quenched gear steels. Simulation is focused on thin, metallic strips that are heat treated to introduce a through-thickness carbon gradient. Because the material properties are strongly dependent on the carbon content, quenching causes significant transverse out-of-plane distortion. The material model accounts for a multiphase alloy structure where inelasticity in the individual phases is temperature and rate dependent. The model is fit to an extensive matrix of experimental data for low carbon steels (0.2–0.8 percent) whose transformation kinetics and mechanical response are similar to 4023 and 4620 alloys used in experiments. While residual stress data are limited, reasonable agreement with X-ray diffraction measurements was obtained. Comparisons of transverse deflections predicted numerically showed excellent agreement with those measured experimentally for all five thicknesses reported. Accurate transformation and lattice carburization strains are critical to correctly predict the sense and magnitude of these transverse distortions and in-plane residual stresses.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSimulating Distortion and Residual Stresses in Carburized Thin Strips
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1543973
dc.journal.fristpage116
dc.journal.lastpage124
dc.identifier.eissn1528-8889
dc.keywordsTemperature
dc.keywordsPhase transitions
dc.keywordsResidual stresses
dc.keywordsStress
dc.keywordsCarbon
dc.keywordsStrips
dc.keywordsCarburization
dc.keywordsPlasticity
dc.keywordsSimulation
dc.keywordsDeformation
dc.keywordsDeflection
dc.keywordsSteel
dc.keywordsHeat AND Alloys
dc.treeJournal of Engineering Materials and Technology:;2003:;volume( 125 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record