Show simple item record

dc.contributor.authorS. Finnie
dc.contributor.authorW. Cheng
dc.contributor.authorI. Finnie
dc.contributor.authorJ. M. Drezet
dc.contributor.authorM. Gremaud
dc.date.accessioned2017-05-09T00:10:21Z
dc.date.available2017-05-09T00:10:21Z
dc.date.copyrightJuly, 2003
dc.date.issued2003
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27049#302_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/128482
dc.description.abstractLaser metal forming is an attractive process for rapid prototyping or the rebuilding of worn parts. However, large tensile stress may arise in layers deposited by laser melting of powder. A potential solution is to preheat the substrate before and during deposition of layers to introduce sufficient contraction during cooling in the substrate to modify the residual stress distribution in the deposited layers. To demonstrate the value of this approach, specimens were prepared by depositing stellite F on a stainless steel substrate with and without preheating. Residual stresses were computed by numerical simulation and measured using the crack compliance method. For non-preheated specimens simulation and experiment agreed well and showed that extremely high residual tensile stresses were present in the laser melted material. By contrast, pre-heated specimens show high compressive stresses in the clad material. However, in this case the numerical simulation and experimental measurement showed very different stress distribution. This is attributed to out of plane deformation due to the high compressive stresses which are not permitted in the numerical simulation. A “strength of materials” analysis of the effect of out of plane deformation was used to correct the simulation, Agreement with experimental results was then satisfactory.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Computation and Measurement of Residual Stresses in Laser Deposited Layers
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1584493
dc.journal.fristpage302
dc.journal.lastpage308
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsLasers
dc.keywordsComputer simulation
dc.keywordsResidual stresses
dc.keywordsSimulation
dc.keywordsStress
dc.keywordsStress concentration
dc.keywordsCladding systems (Building)
dc.keywordsComputation
dc.keywordsFracture (Materials)
dc.keywordsTension
dc.keywordsCompressive stress
dc.keywordsStrength (Materials)
dc.keywordsTemperature AND Metalworking
dc.treeJournal of Engineering Materials and Technology:;2003:;volume( 125 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record