Show simple item record

dc.contributor.authorJon E. Rankin
dc.contributor.authorMichael R. Hill
dc.date.accessioned2017-05-09T00:10:21Z
dc.date.available2017-05-09T00:10:21Z
dc.date.copyrightJuly, 2003
dc.date.issued2003
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27049#283_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/128480
dc.description.abstractThis paper presents measurements of the thickness-average residual stress imposed by laser peening near the edge of a thin sheet of a common titanium alloy. The slitting (or crack compliance) method was extended beyond its typical form to make residual stress measurements in this geometry. An analytical method was employed to optimize the experiment design for the near-edge, thin material geometry, where the design included the optimal number and position of strain gages and the most effective set of basis functions for stress computation. Two experiments were performed on a titanium strip that had been laser peened near the edge, using an optimal experiment design. Residual stress was found to be large and compressive near the edge of the sheet, with the compressive stress extending over 38% of the laser peened area.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMeasurement of Thickness-Average Residual Stress Near the Edge of a Thin Laser Peened Strip
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1584481
dc.journal.fristpage283
dc.journal.lastpage293
dc.identifier.eissn1528-8889
dc.keywordsLasers
dc.keywordsGages
dc.keywordsStress
dc.keywordsStrips
dc.keywordsThickness
dc.keywordsStrain gages AND Functions
dc.treeJournal of Engineering Materials and Technology:;2003:;volume( 125 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record