Show simple item record

dc.contributor.authorC. L. Chow
dc.contributor.authorS. J. Hu
dc.contributor.authorM. Jie
dc.date.accessioned2017-05-09T00:10:21Z
dc.date.available2017-05-09T00:10:21Z
dc.date.copyrightJuly, 2003
dc.date.issued2003
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27049#260_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/128476
dc.description.abstractThis paper presents the development of a generalized method to predict forming limits of sheet metals. The vertex theory, which was developed by Stören and Rice (1975) and recently simplified by Zhu, Weinmann and Chandra (2001), is employed in the analysis to characterize the localized necking (or localized bifurcation) mechanism in elastoplastic materials. The plastic anisotropy of materials is considered. A generalized deformation theory of plasticity is proposed. The theory considers Hosford’s high-order yield criterion (1979), Hill’s quadratic yield criterion and the von Mises yield criterion. For the von Mises yield criterion, the generalized deformation theory reduces to the conventional deformation theory of plasticity, i.e., the J2-theory. Under proportional loading condition, the direction of localized band is known to vary with the loading path at the negative strain ratio region or the left hand side (LHS) of forming limit diagrams (FLDs). On the other hand, the localized band is assumed to be always perpendicular to the major strain at the positive strain ratio region or the right hand side (RHS) of FLDs. Analytical expressions for critical tangential modulus are derived for both LHS and RHS of FLDs. For a given strain hardening rule, the limit strains can be calculated and consequently the FLD is determined. Especially, when assuming power-law strain hardening, the limit strains can be explicitly given on both sides of FLD. Whatever form of a yield criterion is adopted, the LHS of the FLD always coincides with that given by Hill’s zero-extension criterion. However, at the RHS of FLD, the forming limit depends largely on the order of a chosen yield function. Typically, a higher order yield function leads to a lower limit strain. The theoretical result of this study is compared with those reported by earlier researchers for Al 2028 and Al 6111-T4 (Grafand Hosford, 1993; Chow et al., 1997).
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleForming Limit Analysis of Sheet Metals Based on a Generalized Deformation Theory
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1586938
dc.journal.fristpage260
dc.journal.lastpage265
dc.identifier.eissn1528-8889
dc.keywordsPlasticity
dc.keywordsDeformation
dc.keywordsSheet metal
dc.keywordsNecking
dc.keywordsStress
dc.keywordsWork hardening
dc.keywordsBifurcation AND Anisotropy
dc.treeJournal of Engineering Materials and Technology:;2003:;volume( 125 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record