Show simple item record

dc.contributor.authorStuart Barnes
dc.contributor.authorMichael J. Nash
dc.contributor.authorY. K. Kwok
dc.date.accessioned2017-05-09T00:10:19Z
dc.date.available2017-05-09T00:10:19Z
dc.date.copyrightOctober, 2003
dc.date.issued2003
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27052#372_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/128463
dc.description.abstractA 1200 W diode laser was used to modify the surface properties of a fully-sintered ferrous PM material. Two modifications were investigated; transformation hardening of selected areas and sealing of surface porosity by re-melting. The diode laser was used because the beam footprint is large (5×0.5 mm) and the wavelength short (0.94 μm). Processed samples were examined using metallographic and hardness testing techniques. Results indicated that hardness comparable to induction hardening could be achieved and re-melting could be controlled to seal porosity. Further work now needs to be undertaken to convert this demonstrated potential into a commercial reality.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSurface Modification of Powder Metallurgy Components With a Direct Diode Laser
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1605111
dc.journal.fristpage372
dc.journal.lastpage377
dc.identifier.eissn1528-8889
dc.keywordsLasers
dc.keywordsHardening
dc.keywordsElectromagnetic induction
dc.keywordsMelting AND Powder metallurgy
dc.treeJournal of Engineering Materials and Technology:;2003:;volume( 125 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record