Show simple item record

dc.contributor.authorPartha S. Das
dc.contributor.authorSenior R&D Engineer
dc.date.accessioned2017-05-09T00:08:33Z
dc.date.available2017-05-09T00:08:33Z
dc.date.copyrightFebruary, 2002
dc.date.issued2002
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28414#97_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/127384
dc.description.abstractA detailed nonlinear three-dimensional (3-D) finite element analysis (FEA) was performed in Phase I on a NEMO (naval experimental manned observatory) type HBOI (Harbor Branch Oceanographic Institution) spherical acrylic submersible in order to overcome the crack generation problem at its interfaces. An FEA has been carried out to develop a new design guideline, by reducing the higher stresses and relative displacements at the interfaces, which are believed to be two of the main reasons for crack generation at these areas. Variation of the stiffness between dissimilar materials at the interface, lower nylon gasket thickness, overdesigned aluminum hatch and bottom penetrator plug, attachment of the retainer ring with hatch ring, close placement of the rubber padding to the interface between the acrylic sphere, and the retainer ring are found to be the various causes for higher stresses within the acrylic sphere at the nylon gasket/acrylic interface. Based on the new design guidelines, in Phase II, a new spherical acrylic submersible was fabricated and tested. This design resulted in significant improvements by reducing the peak stresses and relative displacements at the gasket/acrylic interface areas. This improvement in design is expected to significantly extend the crack-free cyclic fatigue life of the acrylic submersible at 3000 ft (914 m) ocean depth.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleRedesign of NEMO-Type Spherical Acrylic Submersible for Manned Operation to 3000 ft (914 m) Ocean Depth
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1428746
dc.journal.fristpage97
dc.journal.lastpage107
dc.identifier.eissn1528-8978
dc.keywordsAluminum
dc.keywordsStress
dc.keywordsGaskets
dc.keywordsNylon fabrics
dc.keywordsDesign
dc.keywordsFinite element analysis
dc.keywordsOceans
dc.keywordsSubmersibles
dc.keywordsFracture (Materials) AND Thickness
dc.treeJournal of Pressure Vessel Technology:;2002:;volume( 124 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record