Show simple item record

dc.contributor.authorM. Allam
dc.contributor.authorA. Bazergui
dc.contributor.authorEmeritus Professor of Mechanical Engineering
dc.date.accessioned2017-05-09T00:08:32Z
dc.date.available2017-05-09T00:08:32Z
dc.date.copyrightFebruary, 2002
dc.date.issued2002
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28414#22_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/127373
dc.description.abstractBecause of their importance for the integrity of heat exchangers, the strength of tube-to-tubesheet joints, and particularly their axial strength, is of special interest. A finite element model of an expanded tube-to-tubesheet joint is proposed and examined experimentally with the objective of determining numerically its axial strength. Simplified analytical methods that were previously proposed by many authors to predict the joint axial strength are also used in this investigation. Experimental testing shows that the finite element model is highly accurate for calculating the joint axial strength. The experimental investigation also proves that the pull-out strength is overestimated when calculated using a simple analytical solution. A parametric analysis using the finite element results indicates that the pull-out force is normally lower than the push-out load and that both are lower than the estimations of the analytical solution. The results indicate that the pull-out force as given by the finite element model is generally 35 percent lower than that evaluated by the analytical solution. A difference of as much as 10 percent is also found between the push-out and pull-out loads.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAxial Strength of Tube-to-Tubesheet Joints: Finite Element and Experimental Evaluations
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1398555
dc.journal.fristpage22
dc.journal.lastpage31
dc.identifier.eissn1528-8978
dc.keywordsForce
dc.keywordsPressure
dc.keywordsFriction
dc.keywordsStress
dc.keywordsFinite element analysis
dc.keywordsFinite element model AND Displacement
dc.treeJournal of Pressure Vessel Technology:;2002:;volume( 124 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record