Show simple item record

dc.contributor.authorVladimir Zilberstein
dc.contributor.authorThomas Yentzer
dc.contributor.authorMike Fisher
dc.contributor.authorDavid Grundy
dc.contributor.authorDarrell Schlicker
dc.contributor.authorVladimir Tsukernik
dc.contributor.authorValeriy Vengrinovich
dc.contributor.authorNeil Goldfine
dc.date.accessioned2017-05-09T00:08:30Z
dc.date.available2017-05-09T00:08:30Z
dc.date.copyrightAugust, 2002
dc.date.issued2002
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28420#375_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/127351
dc.description.abstractConformable eddy current sensors with grid methods can provide an effective means for applied stress measurements and for characterization of residual stresses in steel components. This paper describes conformable MWM® (meandering winding magnetometer) sensors and high-resolution scanning MWM-Arrays for directional magnetic permeability measurements over a wide range of frequencies with grid methods. MWMs and MWM-Arrays are used for fatigue monitoring, crack detection, characterization of process-affected layers, including coatings, detection of surface-connected and hidden degradation, and damage characterization, e.g., detection and imaging of grinding burns. Tests have shown that these sensors can also provide the capability for residual/applied stress measurements in ferromagnetic materials, e.g., in steels. Specific examples described here illustrate this capability to estimate stresses in steels and other ferromagnetic materials from MWM measured permeability. Results of directional MWM permeability measurements, including permeability mapping, are presented here for (a) a 4340 steel specimen subjected to a series of tensile load tests with an incrementally increasing maximum load, (b) a broken 4340 tensile test specimen, (c) a shot-peened 300M steel specimen subjected to bending load tests, and (d) a shot-peened and subsequently ground high-strength steel component. Quick and inexpensive stress measurements at a point or, in a scanning mode, over a selected area are now becoming possible without permanently mounting sensors, albeit MWM sensors can be readily mounted, if needed, as well.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleResidual and Applied Stress Estimation From Directional Magnetic Permeability Measurements With MWM Sensors
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1491273
dc.journal.fristpage375
dc.journal.lastpage381
dc.identifier.eissn1528-8978
dc.keywordsPermeability
dc.keywordsSteel
dc.keywordsMeasurement
dc.keywordsSensors
dc.keywordsStress
dc.keywordsImaging
dc.keywordsGrinding
dc.keywordsEddy currents (Electricity) AND Residual stresses
dc.treeJournal of Pressure Vessel Technology:;2002:;volume( 124 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record