Show simple item record

dc.contributor.authorG. C. Butler
dc.contributor.authorS. R. Stock
dc.contributor.authorR. D. McGinty
dc.contributor.authorD. L. McDowell
dc.date.accessioned2017-05-09T00:07:38Z
dc.date.available2017-05-09T00:07:38Z
dc.date.copyrightJanuary, 2002
dc.date.issued2002
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27029#48_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126891
dc.description.abstractThis paper assesses, via X-ray microbeam diffraction, the effects of development of dislocation substructure on the distribution of sub-grain misorientations in annealed OFHC copper deformed to large strains for compression, for shear, and for sequences of compression followed by shear. Polychromatic synchrotron x-radiation was used to study samples from four strain histories: virgin specimens, 50% effective strain in compression, 100% effective strain in torsion, and 50% compressive strain followed by 50% torsion. A very narrow beam illuminated an approximately 15 μm diameter column through the sample, and the microstructure of the specimens was mapped by translating the sample along two orthogonal axes perpendicular to the beam by increments of 10 μm. The beam diameter was considerably smaller than the average grain size in the virgin material. Both the degree of substructure formation and the nature of the distributed microstructure were quantified from the resulting Laue diffraction patterns. The polychromatic diffraction patterns of the polycrystalline samples consisted of well-defined streaks, and the azimuthal angular width of the streaks increased with plastic strain in a manner consistent with the scaling of the misorientation distribution of high angle boundaries for sub-grains reported recently using electron microscopy techniques limited to thin foils or thin surface layers. A lattice spin correction is introduced based on this scaling law in a simple extended Taylor scheme of polycrystal plasticity to achieve a retardation of texture development that is consistent with experimental results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleX-Ray Microbeam Laue Pattern Studies of the Spreading of Orientation in OFHC Copper at Large Strains
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1421050
dc.journal.fristpage48
dc.journal.lastpage54
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsDiffraction
dc.keywordsX-rays
dc.keywordsCopper
dc.keywordsTorsion
dc.keywordsParticle spin
dc.keywordsTexture (Materials)
dc.keywordsCompression
dc.keywordsDislocations
dc.keywordsGrain size
dc.keywordsMicrobeams
dc.keywordsScaling laws (Mathematical physics)
dc.keywordsDiffraction patterns
dc.keywordsPoles (Building) AND Plasticity
dc.treeJournal of Engineering Materials and Technology:;2002:;volume( 124 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record