Show simple item record

dc.contributor.authorKen Gall
dc.contributor.authorHuseyin Sehitoglu
dc.contributor.authorYuriy I. Chumlyakov
dc.contributor.authorMartin L. Dunn
dc.contributor.authorYiping Liu
dc.contributor.authorPaul Labossiere
dc.date.accessioned2017-05-09T00:07:36Z
dc.date.available2017-05-09T00:07:36Z
dc.date.copyrightApril, 2002
dc.date.issued2002
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27032#238_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126876
dc.description.abstractWe present experimental results on the instrumented Vickers micro-indentation and compression of solutionized Ni-rich NiTi single crystals. The tests are conducted at room temperature where the solutionized Ti-50.9 at percent Ni material is 18 degrees above Af and the solutionized Ti-51.5 at percent Ni material is more than 100 degrees above Af. Aside from elastic deformation, it is discovered that dislocation motion and a reversible stress-induced martensitic transformation influence the micro-indentation response of Ti-50.9 at percent Ni, while the micro-indentation of Ti-51.5 at percent Ni only induces irreversible dislocation motion. The effect of the surface normal orientation on material hardness was negligible in the Ti-51.5 at percent Ni and followed trends anticipated by the activation of favorable slip systems in the Ti-50.9 at percent Ni. Compression tests on the identical Ti-50.9 at percent Ni samples revealed deformation by coupled stress-induced martensite and plastic flow, depending on the crystallographic orientation. The trends in hardness with surface normal orientation were not commensurate with the orientation dependence of the uniaxial compressive transformation or “yield” strength. The ramifications of the results in terms of comparing micro-indentation and macro-compression and the interactions between plasticity and the stress-induced martensitic transformation are discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMicro and Macro Deformation of Single Crystal NiTi
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1416684
dc.journal.fristpage238
dc.journal.lastpage245
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsTemperature
dc.keywordsCrystals
dc.keywordsStress
dc.keywordsMartensitic transformations
dc.keywordsNickel titanium alloys
dc.keywordsCompression AND Dislocation motion
dc.treeJournal of Engineering Materials and Technology:;2002:;volume( 124 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record