Show simple item record

dc.contributor.authorM. A. Sutton
dc.contributor.authorD.-Q. Wang
dc.contributor.authorC. R. Hubbard
dc.contributor.authorA. P. Reynolds
dc.date.accessioned2017-05-09T00:07:36Z
dc.date.available2017-05-09T00:07:36Z
dc.date.copyrightApril, 2002
dc.date.issued2002
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27032#215_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126873
dc.description.abstractThree-dimensional residual stress mapping of an aluminum 2024-T3 arcan specimen, butt-welded by the friction stir technique, was performed by neutron diffraction. Results indicate that the residual stress distribution profiles across the weld region are asymmetric with respect to the weld centerline, with the largest gradients in the measured residual stress components occurring on the advancing side of the weld, with the longitudinal stress, σL, oriented along the weld line, as the largest stress. Within the region inside the shoulder diameter, the through-thickness stress, σZ, is entirely compressive, with large gradients occurring along the transverse direction just beyond the shoulder region. In addition, results indicate a significant reduction in the observed residual stresses for a transverse section that was somewhat closer to the free edge of an Arcan specimen. Microstructural studies indicate that the grain size in the weld nugget, is approximately 6.4 microns, with the maximum extent of the recrystallized zone extending to 6 mm on each side of the weld centerline. Outside of this region, the plate material has an unrecrystallized grain structure that consists of pancake shaped grains ranging up to several mm in size in two dimensions and 10 microns in through-thickness dimension.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Study of Residual Stresses and Microstructure in 2024-T3 Aluminum Friction Stir Butt Welds
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1429639
dc.journal.fristpage215
dc.journal.lastpage221
dc.identifier.eissn1528-8889
dc.keywordsFriction
dc.keywordsAluminum
dc.keywordsResidual stresses
dc.keywordsStress
dc.keywordsThickness
dc.keywordsNeutron diffraction
dc.keywordsWelded joints AND Grain size
dc.treeJournal of Engineering Materials and Technology:;2002:;volume( 124 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record