Show simple item record

dc.contributor.authorMichael R. Hill
dc.contributor.authorWei-Yan Lin
dc.date.accessioned2017-05-09T00:07:35Z
dc.date.available2017-05-09T00:07:35Z
dc.date.copyrightApril, 2002
dc.date.issued2002
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27032#185_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126869
dc.description.abstractThis paper presents experimental measurements of the through-thickness distribution of residual stress in a ceramic-metallic functionally graded material (FGM). It further presents an error analysis and optimization of the residual stress measurement technique. Measurements are made in a seven-layered plate with a base of commercially pure titanium and successive layers containing an increasing proportion of titanium-boride, reaching 85% titanium-boride in the final layer. The compliance method is employed to determine residual stress, where a slot is introduced using wire electric-discharge machining and strain release is measured as a function of increasing slot depth. Strain release measurements are used with a back-calculation scheme, based on finite element simulation, to provide residual stresses in the FGM. The analysis is complicated by the variation of material properties in the FGM, but tractable due to the flexibility of the finite element method. The Monte Carlo approach is used for error analysis and a method is described for optimization of the functional form assumed for the residual stresses. The magnitude and variation of the resulting residual stress distributions and several aspects of the error analyses are discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleResidual Stress Measurement in a Ceramic-Metallic Graded Material
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1446073
dc.journal.fristpage185
dc.journal.lastpage191
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsCeramics
dc.keywordsThickness AND Error analysis
dc.treeJournal of Engineering Materials and Technology:;2002:;volume( 124 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record