Show simple item record

dc.contributor.authorD. Arola
dc.contributor.authorC. L. Williams
dc.date.accessioned2017-05-09T00:07:35Z
dc.date.available2017-05-09T00:07:35Z
dc.date.copyrightApril, 2002
dc.date.issued2002
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27032#160_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126864
dc.description.abstractIn this study the influence of machined surface texture on the fatigue strength of a Graphite/Bismaleimide (Gr/Bmi) laminate was examined. Rectangular beam specimens were machined to achieve specific surface roughness (0.2≤Ra≤10.0 μm) and then subjected to fully reversed four-point flexural fatigue. The surface texture resulting from machining was evaluated using contact profilometry and the standard surface roughness parameters were used in estimating the effective stress concentration (K̄t) and effective fatigue notch (K̄f) factors for the machined surfaces according to models reported in the open literature. Fully reversed flexural fatigue loading of the laminate was conducted at two separate maximum bend loads corresponding to Tsai-Hill ratios for first ply failure of 0.75 and 0.9. It was found that the reduction in stiffness of the Gr/Bmi laminate at both levels of fatigue loading increased with the magnitude of surface roughness. The apparent fatigue stress concentration factors (Kf) of the machined surfaces determined from experimental results ranged from 1.0 to 1.2. The effective fatigue notch factors estimated using the Arola-Ramulu model for the machined specimens were within 10% of the corresponding Kf determined from experiments.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSurface Texture, Fatigue, and the Reduction in Stiffness of Fiber Reinforced Plastics
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1416479
dc.journal.fristpage160
dc.journal.lastpage166
dc.identifier.eissn1528-8889
dc.keywordsLaminates
dc.keywordsSurface roughness
dc.keywordsStress
dc.keywordsFatigue
dc.keywordsFiber reinforced plastics
dc.keywordsStiffness
dc.keywordsSurface texture
dc.keywordsStress concentration
dc.keywordsFailure AND Machining
dc.treeJournal of Engineering Materials and Technology:;2002:;volume( 124 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record