Show simple item record

dc.contributor.authorHong-Ki Hong
dc.contributor.authorChein-Shan Liu
dc.contributor.authorYa-Po Shiao
dc.contributor.authorBing-Chang Shih
dc.date.accessioned2017-05-09T00:07:33Z
dc.date.available2017-05-09T00:07:33Z
dc.date.copyrightJuly, 2002
dc.date.issued2002
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27037#314_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126844
dc.description.abstractMany natural minerals and manmade materials are aggregates of crystals or polycrystalline solids with a nonrandom distribution of grain orientations. Macroscopic behavior in such textured polycrystals depends on directions and is thus anisotropic. In this paper we develop experimental and theoretical procedures for investigating grain orientation evolution and its effect on the tensile stress-strain curve. The micro-tensile experiments were executed in a self-developed micro-forcing-heating device together with a micro-recorder-image analyzer system. In the experiments the 0.1 mm thin foil specimens of pure nickel and copper were gradually loaded toward final failure and the evolution of grain boundaries and slip bands inside grains was observed and recorded digitally via microscope and CCD camera throughout the whole time history. The texture image data were then used in a theoretical micro-macro transformation procedure to simulate the orientation evolutions and the stress-strain curves. The procedure was based on a double-slip model of polycrystal plasticity and on averaging of polycrystalline behavior over all grain orientations weighted by an orientation distribution function. The comparisons made between the simulated and experimental data of orientation evolutions and between the simulated curves and the macro-curves concurrently obtained in the experiments confirm the proposed procedures capable of simulating the considered micro-macro relations.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePlanar Double-Slip Model for Polycrystal Plasticity and Micro Tension Tests of Pure Nickel and Copper
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1479355
dc.journal.fristpage314
dc.journal.lastpage321
dc.identifier.eissn1528-8889
dc.keywordsPlasticity
dc.keywordsCopper
dc.keywordsNickel
dc.keywordsStress
dc.keywordsTension
dc.keywordsCrystals
dc.keywordsGrain boundaries
dc.keywordsDeformation
dc.keywordsMicroscopes AND Texture (Materials)
dc.treeJournal of Engineering Materials and Technology:;2002:;volume( 124 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record