Show simple item record

dc.contributor.authorM. A. Sutton
dc.contributor.authorA. P. Reynolds
dc.contributor.authorD.-Q. Wang
dc.contributor.authorC. R. Hubbard
dc.date.accessioned2017-05-09T00:07:32Z
dc.date.available2017-05-09T00:07:32Z
dc.date.copyrightOctober, 2002
dc.date.issued2002
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27039#451_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126829
dc.description.abstractFigure 2 on p. 216 of the article does not have the correct dimensions for the Arcan test specimens. The discrepancy can be seen by comparing Fig. 2 to Fig. 6 in the article. The properly dimensioned drawing for Fig. 2 is shown below along with a note in the figure caption to indicate that the thickness is ≈6.3 mm.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleErratum: “A Study of Residual Stresses and Microstructure in 2024-T3 Aluminum Friction Stir Butt Welds” [ASME J. Eng. Mater. Technol., 124, No. 2, pp. 215–222]
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1511521
dc.journal.fristpage451
dc.identifier.eissn1528-8889
dc.keywordsFriction
dc.keywordsAluminum
dc.keywordsResidual stresses AND Welded joints
dc.treeJournal of Engineering Materials and Technology:;2002:;volume( 124 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record