Show simple item record

dc.contributor.authorPushkar N. Jogi
dc.contributor.authorMichael Neubert
dc.contributor.authorJohn D. Macpherson
dc.date.accessioned2017-05-09T00:07:14Z
dc.date.available2017-05-09T00:07:14Z
dc.date.copyrightSeptember, 2002
dc.date.issued2002
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26504#154_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126657
dc.description.abstractVibrations generated in a drill string while drilling generally lead to a reduction in drilling efficiency and often cause premature failure of drill string components and bit damage. It is also known that lateral vibrations, in particular, are responsible for most measurement-while-drilling (MWD) tool failures while drilling. One way to increase drilling efficiency and avoid tool damage is to monitor and analyze drilling vibrations so that drilling parameters can be adjusted while drilling to reduce such vibrations. An alternative method is to analyze and determine the natural frequencies of the bottom-hole assembly (BHA) so that resonant conditions caused by various excitation mechanisms in the drill string can be avoided. Even though models have been developed in the past in the drilling industry to determine the natural frequencies of a BHA, few attempts have been made to demonstrate that such models do actually help reduce vibrations or failures. This paper deals with the process of field validation of model-derived frequencies for axial, torsional and lateral vibrations. The results presented in this paper are based on the analysis of drilling data from a field test using downhole vibration measurement sensors. The downhole measurements included X and Y bending moments, axial acceleration, dynamic weight-on-bit, dynamic torque, and X and Y-axis magnetometers mounted in an MWD sub. The data analysis demonstrates that the natural frequencies predicted by the models match well with actual field (measured) values at the locations of interest, particularly for lateral vibrations. This analysis therefore shows that model derived results can be used with a degree of confidence to help avoid resonant conditions in a BHA while drilling and to help reduce failures.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleField Verification of Model-Derived Natural Frequencies of a Drill String
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.1486018
dc.journal.fristpage154
dc.journal.lastpage162
dc.identifier.eissn1528-8994
dc.keywordsDrills (Tools)
dc.keywordsString
dc.keywordsVibration
dc.keywordsFrequency
dc.keywordsDrilling AND Measurement
dc.treeJournal of Energy Resources Technology:;2002:;volume( 124 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record