Show simple item record

dc.contributor.authorH. Karasawa
dc.contributor.authorJ. C. Rowley
dc.contributor.authorT. Ohno
dc.contributor.authorM. Kosugi
dc.date.accessioned2017-05-09T00:07:14Z
dc.date.available2017-05-09T00:07:14Z
dc.date.copyrightSeptember, 2002
dc.date.issued2002
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26504#125_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126652
dc.description.abstractThis paper proposes new methods to estimate both the rock strength and tooth wear while drilling with roller-bits. Laboratory drilling tests were conducted to obtain the penetration rate, bit weight and torque using milled-tooth bits with different tooth wear (T0, T4, T7). Drilling media used for the tests were soft to medium-hard rocks whose uniaxial compressive strength ranged from 14 to 118 MPa. Based on the test results, a parameter, which presents the rock strength independent of the tooth wear, was first investigated. The investigation revealed that a parameter related to the axial energy and the rotary energy required to drill rock is effective to estimate the rock strength independent of the tooth wear. Second, methods to estimate the tooth wear were studied based on the same parameter that represents the rock strength. From the results of this study, methods to measure the tooth wear are proposed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMethods to Estimate the Rock Strength and Tooth Wear While Drilling With Roller-Bits—Part 1: Milled-Tooth Bits
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.1482405
dc.journal.fristpage125
dc.journal.lastpage132
dc.identifier.eissn1528-8994
dc.keywordsWear
dc.keywordsDrilling
dc.keywordsRocks AND Rollers
dc.treeJournal of Energy Resources Technology:;2002:;volume( 124 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record