Show simple item record

dc.contributor.authorD. Economou
dc.contributor.authorResearch Assistant
dc.contributor.authorC. Mavroidis
dc.contributor.authorMem. ASME Associate Professor
dc.contributor.authorI. Antoniadis
dc.contributor.authorMem. ASME Assistant Professor
dc.contributor.authorC. Lee
dc.date.accessioned2017-05-09T00:07:06Z
dc.date.available2017-05-09T00:07:06Z
dc.date.copyrightMarch, 2002
dc.date.issued2002
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26296#85_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126543
dc.description.abstractA method for suppressing residual vibrations in flexible systems is presented and experimentally demonstrated. The proposed method is based on the preconditioning of the inputs to the system using low-pass Finite Impulse Response (FIR) digital filters. Provided that the cutoff frequency of FIR filters is selected lower than the lowest expected natural frequency of the system and their stop-band is maximized, we show that these filters can be designed to exhibit maximally robust behavior with respect to changes of the system natural frequencies. To perform the proper design of FIR filters for robust vibration suppression, this paper introduces a series of dimensionless performance indexes and the Delay-Error-Order (DEO) curves that represent graphically the delay time introduced by the filter as a function of the remaining residual vibrations, and the filter order. Several classes of FIR filters such as: a) Parks-McClellan; b) Window-based methods (using Chebyshev window); and c) Constrained Least Squares method, are shown to present maximally robust behavior, almost identical to the theoretically predicted. Parallel, they demonstrate excellent vibration suppression while they introduce the minimum possible delay. Further advantages offered by the proposed method, is that no modeling of the flexible system is required, the method can be used in a variety of systems exhibiting vibrations, it is independent of the guidance function and it is simple to implement in practical applications. The results are experimentally verified on a flexible aluminum beam with a significantly varying mass, attached to the end-effector of a robot manipulator. The beam is rotated, using one joint of the manipulator, from an initial to a final position. It is shown that the preconditioned inputs to the flexible system induce very little amount of residual vibrations compared to the inputs with no preconditioning.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMaximally Robust Input Preconditioning for Residual Vibration Suppression Using Low-Pass FIR Digital Filters
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue1
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.1434272
dc.journal.fristpage85
dc.journal.lastpage97
dc.identifier.eissn1528-9028
dc.keywordsVibration
dc.keywordsVibration suppression
dc.keywordsFilters
dc.keywordsFinite impulse response filters
dc.keywordsDelays
dc.keywordsErrors
dc.keywordsDesign AND Robustness
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2002:;volume( 124 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record