Show simple item record

dc.contributor.authorG. M. Peel
dc.contributor.authorG. A. Parker
dc.date.accessioned2017-05-09T00:07:03Z
dc.date.available2017-05-09T00:07:03Z
dc.date.copyrightDecember, 2002
dc.date.issued2002
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26308#675_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126505
dc.description.abstractCutting brushes are used at relatively low speeds by various municipal vehicles and in particular road sweeping units. As the name suggests such brushes are designed to “cut” through debris, especially compacted sand or similar matter. The main deflection plane of a bristle (or tine) is along the mount radius, making the tines very stiff in the direction of rotation, hence the cutting action when the brush is rotated. Exploring the literature shows that very little is known, or understood, about the operation of brushes for mechanical sweeping. In this paper a pseudo-static discretized model is developed to investigate the deformations and forces acting on brushes during ideal operation of a horizontal brush on a flat plane. Due to the numerous different sweeper brushes on the market, one common configuration is used as the basis of the model and the paper will detail only the characteristics of this brush. The brush to be investigated is a “cutting brush,” introduced above, where the tines can only deflect along the mount radius. Having developed a model it is used to predict the forces and torques generated within a horizontally rotating brush. The influence of centrifugal force is analyzed although transient effects are neglected and steady state conditions assumed. The predictions of the model are compared to practical results taken from a test rig and the validity of the model is discussed. Agreement between the model and the practical results will be shown to be good, considering the complexities and practical realities involved in analyzing any system which is friction dependent.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleInitial Investigations Into the Dynamics of Cutting Brushes for Sweeping
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue4
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.1515333
dc.journal.fristpage675
dc.journal.lastpage681
dc.identifier.eissn1528-9028
dc.keywordsFriction
dc.keywordsCentrifugal force
dc.keywordsStress
dc.keywordsCutting
dc.keywordsDeflection
dc.keywordsRoads
dc.keywordsSteady state
dc.keywordsDynamics (Mechanics)
dc.keywordsForce
dc.keywordsDeformation
dc.keywordsVehicles AND Torque
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2002:;volume( 124 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record