Show simple item record

dc.contributor.authorJohn H. Underwood
dc.contributor.authorMichael J. Glennon
dc.date.accessioned2017-05-09T00:05:51Z
dc.date.available2017-05-09T00:05:51Z
dc.date.copyrightFebruary, 2001
dc.date.issued2001
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28407#150_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/125788
dc.description.abstractLaboratory fatigue life results are summarized from several test series of high-strength steel cannon breech closure assemblies pressurized by rapid application of hydraulic oil. The tests were performed to determine safe fatigue lives of high-pressure components at the breech end of the cannon and breech assembly. Careful reanalysis of the fatigue life tests provides data for stress and fatigue life models for breech components, over the following ranges of key parameters: 380–745 MPa cyclic internal pressure; 100–160 mm bore diameter cannon pressure vessels; 1040–1170 MPa yield strength A723 steel; no residual stress, shot peen residual stress, overload residual stress. Modeling of applied and residual stresses at the location of the fatigue failure site is performed by elastic-plastic finite element analysis using ABAQUS and by solid mechanics analysis. Shot peen and overload residual stresses are modeled by superposing typical or calculated residual stress distributions on the applied stresses. Overload residual stresses are obtained directly from the finite element model of the breech, with the breech overload applied to the model in the same way as with actual components. Modeling of the fatigue life of the components is based on the fatigue intensity factor concept of Underwood and Parker, a fracture mechanics description of life that accounts for residual stresses, material yield strength and initial defect size. The fatigue life model describes six test conditions in a stress versus life plot with an R2 correlation of 0.94, and shows significantly lower correlation when known variations in yield strength, stress concentration factor, or residual stress are not included in the model input, thus demonstrating the model sensitivity to these variables.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStress and Fatigue Life Modeling of Cannon Breech Closures Including Effects of Material Strength and Residual Stress
dc.typeJournal Paper
dc.journal.volume123
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1320442
dc.journal.fristpage150
dc.journal.lastpage154
dc.identifier.eissn1528-8978
dc.keywordsModeling
dc.keywordsStress
dc.keywordsFatigue life
dc.keywordsYield strength
dc.keywordsFinite element analysis
dc.keywordsStrength (Materials)
dc.keywordsPressure
dc.keywordsFatigue
dc.keywordsStress concentration AND Residual stresses
dc.treeJournal of Pressure Vessel Technology:;2001:;volume( 123 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record