Show simple item record

dc.contributor.authorMakoto Hayashi
dc.contributor.authorKunio Enomoto
dc.date.accessioned2017-05-09T00:05:51Z
dc.date.available2017-05-09T00:05:51Z
dc.date.copyrightFebruary, 2001
dc.date.issued2001
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28407#130_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/125784
dc.description.abstractChanges in the residual stress in a worked surface layer of type 304 austenitic stainless steel due to tensile deformation were measured by the X-ray diffraction residual stress measuring method. The compressive residual stresses introduced by end-mill, end-mill side cutter, and grinder were easily changed into tensile stresses when the plate specimens were subjected to tensile stress greater than the yield stress of the solid solution heat-treated material. The residual stresses after the tensile deformation depend on the initial residual stresses and the degree of preliminary working. The behavior of the residual stress changes can be interpreted if the surface-worked material is regarded as a composite made of solid solution heat-treated material and work-hardened material.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleChanges in Residual Stress in Worked Surface Layer of Type 304 Austenitic Stainless Steel Due to Tensile Deformation
dc.typeJournal Paper
dc.journal.volume123
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1339006
dc.journal.fristpage130
dc.journal.lastpage134
dc.identifier.eissn1528-8978
dc.keywordsResidual stresses
dc.keywordsStress
dc.keywordsStainless steel
dc.keywordsDeformation
dc.keywordsHeat AND Tension
dc.treeJournal of Pressure Vessel Technology:;2001:;volume( 123 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record