Show simple item record

dc.contributor.authorP. Dong
dc.date.accessioned2017-05-09T00:05:48Z
dc.date.available2017-05-09T00:05:48Z
dc.date.copyrightMay, 2001
dc.date.issued2001
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28100#207_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/125755
dc.description.abstractIn this paper, detailed weld residual stress analyses are presented for a typical multi-pass girth weld in Type 316L stainless steel pipe with r/t ratio of 25. Advanced finite element procedures were used to simulate the residual stress development under controlled welding conditions associated with weld mock-ups. Both axisymmetric and 3-D special shell element models were used to reveal local residual stress details and global residual stress characteristics in the girth weld. Residual stress measurements using hole-drilling method were conducted for model validation on the laboratory weld mock-up welds. A good agreement between finite element predictions and experimental measurements were obtained. The major findings include: (a) Axial residual stresses within and near the weld area exhibit a strong bending feature across the pipe wall thickness, while the hoop residual stresses showed a much less variation through the wall thickness. (b) Some periodic variation of the residual stresses is present along the pipe circumference near the weld, particularly for the axial residual stress component. Such a variation tends to become more pronounced in thick wall than in thin wall girth welds. A 3-D model is essential to adequately capture such 3-D features in residual stress distributions. (c) A rapid variation in weld residual stresses can be seen at start/stop positions, where a high magnitude of axial residual stresses is present in both tension and compression.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleResidual Stress Analyses of a Multi-Pass Girth Weld: 3-D Special Shell Versus Axisymmetric Models
dc.typeJournal Paper
dc.journal.volume123
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1359527
dc.journal.fristpage207
dc.journal.lastpage213
dc.identifier.eissn1528-8978
dc.keywordsWelding
dc.keywordsResidual stresses
dc.keywordsStress analysis (Engineering)
dc.keywordsFinite element analysis
dc.keywordsPipes
dc.keywordsStress
dc.keywordsShells
dc.keywordsMeasurement AND Wall thickness
dc.treeJournal of Pressure Vessel Technology:;2001:;volume( 123 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record