Show simple item record

dc.contributor.authorA. A. Garcia-Granada
dc.contributor.authorP. Holdway
dc.contributor.authorD. J. Smith
dc.contributor.authorM. J. Pavier
dc.contributor.authorV. D. Lacarac
dc.date.accessioned2017-05-09T00:05:05Z
dc.date.available2017-05-09T00:05:05Z
dc.date.copyrightJanuary, 2001
dc.date.issued2001
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27017#125_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/125347
dc.description.abstractThe cold expansion of fastener holes in aircraft components is a standard technique to improve fatigue life. There is concern that the beneficial residual stresses arising from cold expansion may relax due to creep. This paper describes experimental measurement and finite element prediction of cold expansion residual stresses and their redistribution after creep, with and without additional mechanical load. Experimental measurements of near-surface stresses used an X-ray diffraction technique while average through-the-thickness stresses were measured using a new method based on Sachs’ boring. This new method allowed non-axisymmetric residual stresses to be measured, as was the case when creep relaxation occurred with mechanical load. Axisymmetric and three dimensional finite element analyses were used to predict the stress distribution through the thickness of the component showing good agreement with measurement. Creep relaxation of residual stress does indeed occur, but some benefit of the cold expansion remains, particularly when creep relaxation is combined with the application of mechanical load.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCreep Relaxation of Residual Stresses Around Cold Expanded Holes
dc.typeJournal Paper
dc.journal.volume123
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1310305
dc.journal.fristpage125
dc.journal.lastpage131
dc.identifier.eissn1528-8889
dc.keywordsMeasurement
dc.keywordsResidual stresses
dc.keywordsStress
dc.keywordsAeroelasticity
dc.keywordsFinite element analysis
dc.keywordsCreep AND Thickness
dc.treeJournal of Engineering Materials and Technology:;2001:;volume( 123 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record