Show simple item record

dc.contributor.authorH.-P. Gänser
dc.contributor.authorA. G. Atkins
dc.contributor.authorO. Kolednik
dc.contributor.authorF. D. Fischer
dc.contributor.authorO. Richard
dc.date.accessioned2017-05-09T00:05:05Z
dc.date.available2017-05-09T00:05:05Z
dc.date.copyrightJanuary, 2001
dc.date.issued2001
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27017#94_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/125341
dc.description.abstractTwo damage indicators for ductile failure, as proposed by Hancock–Mackenzie–Gunawardena and Atkins, are compared with experimental results from literature for the upsetting process of cylindrical specimens. It is shown, for this specific example, that quite similar results can be obtained from highly different damage indicators as long as they allow for the accumulation of damage proportional both to the equivalent strain and to the stress triaxiality; the specific mathematical structure of the indicator seems to be of minor importance. These findings give some guidelines for the practical choice of a damage indicator for the simulation of industrial forming processes, and suggest the use of the void growth based Hancock–Mackenzie–Gunawardena indicator even for a certain class of bulk forming processes. In addition, a slight geometry dependence of the failure lines obtained by the Hancock–Mackenzie–Gunawardena indicator is obtained that has so far neither been reported by experimentalists, nor can it be reproduced in a comparable manner by the Atkins indicator. A surprising correlation is found between these results and those obtained from an entirely different micromechanical analysis proposed recently by one of the authors.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleUpsetting of Cylinders: A Comparison of Two Different Damage Indicators
dc.typeJournal Paper
dc.journal.volume123
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1286186
dc.journal.fristpage94
dc.journal.lastpage99
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsCylinders
dc.keywordsFailure
dc.keywordsGeometry
dc.keywordsCalibration AND Compression
dc.treeJournal of Engineering Materials and Technology:;2001:;volume( 123 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record