Show simple item record

dc.contributor.authorM. B. Prime
dc.contributor.authorTechnical Staff Member
dc.date.accessioned2017-05-09T00:05:03Z
dc.date.available2017-05-09T00:05:03Z
dc.date.copyrightApril, 2001
dc.date.issued2001
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27019#162_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/125316
dc.description.abstractA powerful new method for residual stress measurement is presented. A part is cut in two, and the contour, or profile, of the resulting new surface is measured to determine the displacements caused by release of the residual stresses. Analytically, for example using a finite element model, the opposite of the measured contour is applied to the surface as a displacement boundary condition. By Bueckner’s superposition principle, this calculation gives the original residual stresses normal to the plane of the cut. This “contour method” is more powerful than other relaxation methods because it can determine an arbitrary cross-sectional area map of residual stress, yet more simple because the stresses can be determined directly from the data without a tedious inversion technique. The new method is verified with a numerical simulation, then experimentally validated on a steel beam with a known residual stress profile.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCross-Sectional Mapping of Residual Stresses by Measuring the Surface Contour After a Cut
dc.typeJournal Paper
dc.journal.volume123
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1345526
dc.journal.fristpage162
dc.journal.lastpage168
dc.identifier.eissn1528-8889
dc.keywordsResidual stresses AND Stress
dc.treeJournal of Engineering Materials and Technology:;2001:;volume( 123 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail
This item appears in the following Collection(s)

Show simple item record