Show simple item record

dc.contributor.authorKuo-Kuang Chen
dc.contributor.authorChung-Yeh Sa
dc.date.accessioned2017-05-09T00:05:00Z
dc.date.available2017-05-09T00:05:00Z
dc.date.copyrightOctober, 2001
dc.date.issued2001
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27024#447_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/125280
dc.description.abstractThis paper studies the effects of some modeling parameters on the accuracy of finite element simulation in sheet-metal forming. A simple stepdie, which simulates binder forming, is used. In this two-dimensional case, a flat blank is bent into an S-shape, which has an exact solution. Four modeling parameters are studied. They are: die close speed, die gap, mass damping, and width of blank. One significant finding of this study reveals that in calculations using explicit finite elements, the simulation speed should be selected with care. The dynamic effects may be prevalent if the simulation speed is too fast. Numerical errors may accumulate and renders the results erroneous if it is too slow.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffects of Some Modeling Parameters of Finite Element Models of Binder Forming
dc.typeJournal Paper
dc.journal.volume123
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1395578
dc.journal.fristpage447
dc.journal.lastpage455
dc.identifier.eissn1528-8889
dc.keywordsBinders (Materials)
dc.keywordsSimulation
dc.keywordsDamping
dc.keywordsModeling
dc.keywordsBlanks
dc.keywordsOscillations
dc.keywordsShapes
dc.keywordsFinite element analysis
dc.keywordsSimulation results AND Errors
dc.treeJournal of Engineering Materials and Technology:;2001:;volume( 123 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record