Show simple item record

dc.contributor.authorGuohua Zhang
dc.contributor.authorXin Wu
dc.contributor.authorS. Jack Hu
dc.date.accessioned2017-05-09T00:05:00Z
dc.date.available2017-05-09T00:05:00Z
dc.date.copyrightOctober, 2001
dc.date.issued2001
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27024#436_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/125276
dc.description.abstractIn this paper, the occurrence of recoil and surface warp during the flat surface-straight edge hemming process is investigated. A general-purpose finite element code ABAQUS/Standard is used to simulate the hemming operations. Reverse bending and springback are the fundamental mechanisms that cause surface warp and recoil. Recoil and warp are not independent. One parameter, final equivalent warp, is used to represent both. Pre-hemming target ending position is proposed based on the minimization of the final equivalent warp. The influence of the geometrical and process parameters on recoil and warp are also discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Study on Fundamental Mechanisms of Warp and Recoil in Hemming
dc.typeJournal Paper
dc.journal.volume123
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1396348
dc.journal.fristpage436
dc.journal.lastpage441
dc.identifier.eissn1528-8889
dc.keywordsWarping
dc.keywordsMechanisms AND Finite element analysis
dc.treeJournal of Engineering Materials and Technology:;2001:;volume( 123 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record