Show simple item record

dc.contributor.authorKamran Nikbin
dc.date.accessioned2017-05-09T00:03:18Z
dc.date.available2017-05-09T00:03:18Z
dc.date.copyrightFebruary, 2000
dc.date.issued2000
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28396#40_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/124241
dc.description.abstractIn both power generation plants and the chemical industries, there is a need to assess the significance of defects which may exist in high-temperature equipment operating in the creep range. This paper examines the methods of analysis used in laboratory creep crack growth data and their relevance to crack growth data derived from feature component tests which best simulate actual components under controlled testing condition. The material examined was a 214 Cr 1 Mo steel in the new condition at 550 and 600°C. The creep crack growth properties were determined on compact tension specimens. The data were compared with representative crack growth data from feature test components. These consisted of cracked rings, thick-walled cylinders, and thin-walled tubes containing axial or circumferential defects under combinations of axial and internal pressure loading. Little influence of size or temperature on the measured crack propagation rates was observed when the results were plotted against the creep fracture mechanics parameter C*. This is shown to be because the relevant condition had little effect on the appropriate crack tip creep ductilities of the material. Good correspondence was observed between the compact tension and the feature component tests, suggesting the feasibility of the C* method for predicting short-term laboratory tests using different geometries. [S0094-9930(00)01001-5]
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleComparison Between Crack Growth in Fracture Mechanics Specimens and Feature Component Tests Carried Out in a Low-Alloy Steel
dc.typeJournal Paper
dc.journal.volume122
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.556147
dc.journal.fristpage40
dc.journal.lastpage44
dc.identifier.eissn1528-8978
dc.keywordsCreep
dc.keywordsFracture mechanics
dc.keywordsSteel
dc.keywordsFracture (Materials)
dc.keywordsStress AND Tension
dc.treeJournal of Pressure Vessel Technology:;2000:;volume( 122 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record