Show simple item record

dc.contributor.authorRobert L. Sindelar
dc.contributor.authorLeta Y. Woo
dc.contributor.authorPoh-Sang Lam
dc.contributor.authorGeorge R. Caskey
dc.date.accessioned2017-05-09T00:03:17Z
dc.date.available2017-05-09T00:03:17Z
dc.date.copyrightMay, 2000
dc.date.issued2000
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28398#162_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/124224
dc.description.abstractMechanical properties of 1950’s vintage, A285 Grade B carbon steels have been compiled for elastic-plastic fracture mechanics analysis of storage tanks (Lam and Sindelar, 2000). The properties are from standard Charpy V-notch (CVN), 0.4T planform compact tension (C(T)), and tensile (T) specimens machined from archival steel from large water piping. The piping and storage tanks were constructed in the 1950s from semi-killed, hot-rolled carbon steel plate specified as A285 Grade B. Evaluation of potential aging mechanisms at both service conditions shows no loss in fracture resistance of the steel in either case. Site and literature data show that the A285, Grade B steel, at and above approximately 70°F (21°C), is in the upper transition to upper shelf region for absorbed energy and is not subject to cleavage cracking or a brittle fracture mode. Furthermore, the tank sidewalls are 1/2 or 5/8-in. (12.7 or 15.875 mm) thick, and therefore, the J-resistance (JR) curve that characterizes material resistance to stable crack extension under elastic-plastic deformation best defines the material fracture toughness. The JR, curves for several heats of A285, Grade B steel tested at 40°F (4.4°C), a temperature near the average ductile-to-brittle (DBTT) transition temperature (CVN at 15 ft-lb or 20.3 J), are presented. This data is applicable to evaluate flaw stability of the storage tanks that are operated above 70°F (21°C) since, even at 40°F (4.4°C), crack advance is observed to proceed by ductile tearing. [S0094-9930(00)00402-9]
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFlaw Stability in Mild Steel Tanks in the Upper-Shelf Ductile Range—Part I: Mechanical Properties
dc.typeJournal Paper
dc.journal.volume122
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.556173
dc.journal.fristpage162
dc.journal.lastpage168
dc.identifier.eissn1528-8978
dc.keywordsSteel
dc.keywordsMechanical properties
dc.keywordsPipes
dc.keywordsStorage tanks
dc.keywordsCarbon steel
dc.keywordsStability
dc.keywordsFracture (Process)
dc.keywordsTemperature AND Carbon
dc.treeJournal of Pressure Vessel Technology:;2000:;volume( 122 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record