Show simple item record

dc.contributor.authorI. Zarudi
dc.contributor.authorL. C. Zhang
dc.date.accessioned2017-05-09T00:02:36Z
dc.date.available2017-05-09T00:02:36Z
dc.date.copyrightJanuary, 2000
dc.date.issued2000
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27003#129_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/123807
dc.description.abstractThis paper investigates both experimentally and theoretically the subsurface damage in alumina by ductile-mode griding. It found that the distribution of the fractured area on a ground mirror surface, with the Rms roughness in the range from 30 nm to 90 nm, depends on not only the grinding conditions but also the pores in the bulk material. Surface pit formation is the result of interaction of abrasive grains of the grinding wheel with pores. Thus the surface quality achievable by ductile-mode grinding is limited by the initial microstructure of a material. The investigation shows that median and radial cracks do not appear and hence are not the cause of fracture as usually thought. [S0094-4289(00)02001-6]
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleOn the Limit of Surface Integrity of Alumina by Ductile-Mode Grinding
dc.typeJournal Paper
dc.journal.volume122
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.482776
dc.journal.fristpage129
dc.journal.lastpage134
dc.identifier.eissn1528-8889
dc.keywordsGrinding AND Fracture (Process)
dc.treeJournal of Engineering Materials and Technology:;2000:;volume( 122 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record