| dc.contributor.author | David A. Miller | |
| dc.contributor.author | Dimitris C. Lagoudas | |
| dc.date.accessioned | 2017-05-09T00:02:35Z | |
| dc.date.available | 2017-05-09T00:02:35Z | |
| dc.date.copyright | January, 2000 | |
| dc.date.issued | 2000 | |
| dc.identifier.issn | 0094-4289 | |
| dc.identifier.other | JEMTA8-27003#74_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/123797 | |
| dc.description.abstract | Titanium alloys are commonly heat-treated to meet specific design requirements. In an effort to possibly create a better composite, the influence of heat treatments on the damage evolution and strength of a SiC/Ti-15-3 metal matrix composite (MMC) was studied. Heat treatments of 450°C and 700°C for 24 hours were performed on axial and transverse unidirectional specimens. These specimens, in addition to specimens in the as-received condition, were tested under nonproportional loading paths and then microstructurally analyzed to determine the induced damage. The axial composite with the 450°C heat treatment showed the highest elastic modulus and the lowest stiffness reduction than the other heat treatment conditions. The transverse composite in the as-received condition showed the highest room temperature elastic modulus and the lowest stiffness reduction compared with other heat treatment conditions. Typical damage modes of Ti MMC’s, such as fiber/matrix debonding and matrix microcracking, were seen in all heat treatments. A micromechanics model based on the Mori-Tanaka averaging scheme was implemented to simulate the effects of micro-cracking induced damage on composite stiffness reduction. [S0094-4289(00)01101-4] | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Influence of Heat Treatment on the Mechanical Properties and Damage Development in a SiC/Ti-15-3 MMC | |
| dc.type | Journal Paper | |
| dc.journal.volume | 122 | |
| dc.journal.issue | 1 | |
| dc.journal.title | Journal of Engineering Materials and Technology | |
| dc.identifier.doi | 10.1115/1.482768 | |
| dc.journal.fristpage | 74 | |
| dc.journal.lastpage | 79 | |
| dc.identifier.eissn | 1528-8889 | |
| dc.keywords | Heat | |
| dc.keywords | Temperature | |
| dc.keywords | Composite materials | |
| dc.keywords | Fibers | |
| dc.keywords | Stress | |
| dc.keywords | Heat treating (Metalworking) | |
| dc.keywords | Fracture (Materials) | |
| dc.keywords | Elastic moduli | |
| dc.keywords | Stiffness | |
| dc.keywords | Deformation AND Mechanical properties | |
| dc.tree | Journal of Engineering Materials and Technology:;2000:;volume( 122 ):;issue: 001 | |
| dc.contenttype | Fulltext | |