Show simple item record

dc.contributor.authorXiao Lin
dc.date.accessioned2017-05-09T00:02:35Z
dc.date.available2017-05-09T00:02:35Z
dc.date.copyrightJanuary, 2000
dc.date.issued2000
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27003#42_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/123792
dc.description.abstractMacroscopic response and microscopic dislocation structures of Zr-4 subjected to biaxial fatigue under different phase angles of 30°, 60°, 90° and different equivalent strain ranges of 0.8%, 0.6%, 0.4% were studied. The testing results show that the delay angle between the stress deviators and strain increment tensors is strongly dependent on phase angle and the equivalent strain range. When phase angle equals 60°, the delay angle has the minimum variation range for all specimens. The mean value of the delay angle decreases with increasing phase angle or the equivalent strain range. The variation range and average value of the Mises equivalent stress have the maximum in S3 with the phase angle of 90°. They decrease as the equivalent strain range decreases. Zr-4 displays a pronounced initial hardening followed by a continuous softening for all specimens during out-of-phase cycling. The stabilized saturation stresses of Zr-4 under out-of-phase cycling are much higher than that under uniaxial cycling. It indicates that Zr-4 displays an obvious additional hardening. As the phase angle increases, the typical dislocation structure changes from dislocation cells to tangles. The dislocation-dislocation interactions increase resulting in an additional hardening. In essence, the degree of additional hardening depends, among other factors, on the maximum shear stress ratio of resolved shear stresses and critical resolved shear stresses (RSS/CRSS). [S0094-4289(00)00601-0]
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCyclic Deformation Behavior and Dislocation Substructures of Hexagonal Zircaloy-4 Under Out-of-Phase Loading
dc.typeJournal Paper
dc.journal.volume122
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.482763
dc.journal.fristpage42
dc.journal.lastpage48
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsStress
dc.keywordsHardening
dc.keywordsDislocations
dc.keywordsZirconium
dc.keywordsShear (Mechanics)
dc.keywordsDelays
dc.keywordsTensors AND Testing
dc.treeJournal of Engineering Materials and Technology:;2000:;volume( 122 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record